2000 Ford Explorer Service Manual

After three driving cycles without these or any other temporary malfunctions present, the Check Engine light should turn off. Do not use fuel containing methanol. Adjust the heating or air conditioning if equipped to bring in fresh air.

Press front to raise or lower the front portion of the seat cushion. Fold the edges of the vinyl towards the center, making sure that the edges clear the end cap slots.

Ford Explorer

Since sudden changes in terrain can result in abrupt steering wheel motion, make sure you grip the steering wheel from the outside. Reproduction by any means, electronic or mechanical including. Enter the factory-set code keypad will illuminate when pressed. Pull the panel cover outward to access the fuses.


Use only fluid that meets Ford specifications. Ford Motor Company has not approved a slingbelt towing procedure. Ford offers tire cables as a Ford approved accessory and recommends use of these or their equivalents. Place the gearshift in N Neutral automatic transmission or depress the clutch manual transmission.

The handle will stop moving and forward resistance to turning will be felt when properly engaged. Not all vehicles qualify for A, Z or X Plan.

Ford Explorer Auto Repair Manual - ChiltonDIY

If not, possible damage may occur to the liftgate door lift cylinders and attaching hardware. The advertised capacity is the amount of the indicated capacity and the empty reserve combined. Open the liftgate to expose the lamp assemblies.

Find Your Owner Manual Warranty & More

Pressing the control for more than three seconds results in fast rewind. Always provide proper ventilation.

To control fan speed manually, use the thumbwheel or steering wheel control to cancel automatic fan speed operation. This gauge indicates the temperature of the engine coolant, anonymous surfing software not the coolant level. High beams Illuminates when the high beam headlamps are turned on.

Press and release the HomeLink button a second time to complete the training process. Ensure that you turn off your speed control.

Transmission fluid requirements are indicated on the dipstick or on the dipstick handle. When starting a fuel-injected engine, avoid pressing the accelerator before or during starting. Use the following procedure to reset the fuel pump shut-off switch. Apply the accelerator slowly and avoid spinning the wheels.

Instead, gradually decrease your speed. An explosion could result in injury or vehicle damage. Failure to do so may damage the transmission. Android is a trademark of Google Inc.

Make sure the headlamps and vehicle accessories are off. Allow the belt to retract. If it enters the red section, the engine is overheating. Page Driving Automatic transmissions may shift frequently while driving up steep grades. Page Cleaning the exterior lamps Wash with the same detergent as the exterior of your vehicle.

Owner Manuals

Ford 2000 Explorer Owner s Manual

To program position one, move the driver seat to the desired position using the seat controls. Use a lower gear when towing up or down steep hills. Do not tow with a slingbelt.


The air conditioning compressor can operate in all modes except. Start the engine of the booster vehicle and run the engine at moderately increased speed.